RFC3992 Media Gateway Control Protocol (MGCP) Lockstep State ReportingMechanism

3992 Media Gateway Control Protocol (MGCP) Lockstep State ReportingMechanism. B. Foster, F. Andreasen. February 2005. (Format: TXT=9718 bytes) (Status: INFORMATIONAL)

日本語訳
RFC一覧

参照

Network Working Group                                          B. Foster
Request for Comments: 3992                                  F. Andreasen
Category: Informational                                    Cisco Systems
                                                           February 2005


                 Media Gateway Control Protocol (MGCP)
                  Lockstep State Reporting Mechanism

Status of This Memo

   This memo provides information for the Internet community.  It does
   not specify an Internet standard of any kind.  Distribution of this
   memo is unlimited.

Copyright Notice

   Copyright (C) The Internet Society (2005).

IESG Note

   This document is being published for the information of the
   community.  It describes a non-IETF protocol that is currently being
   deployed in a number of products.  Implementers should be aware of
   RFC 3015, which was developed in the IETF Megaco Working Group and
   the ITU-T SG16, and which is considered the standards-based
   (including reviewed security considerations) way to meet the needs
   that MGCP was designed to address by the IETF and the ITU-T.

Abstract

   A Media Gateway Control Protocol (MGCP) endpoint that has encountered
   an adverse failure condition (such as being involved in a transient
   call when a Call Agent failover occurred) could be left in a lockstep
   state whereby events are quarantined but not notified.  The MGCP
   package described in this document provides a mechanism for reporting
   these situations so that the new Call Agent can take the necessary
   fault recovery procedures.

1.  Introduction

   In the Media Gateway Control Protocol (MGCP) [2], when an endpoint
   operating in "step" mode generates a Notify, it will enter the
   notification state, where it waits for a response to the Notify.
   Furthermore, the endpoint must wait for a new NotificationRequest
   before it can resume event processing.  As long as the endpoint is
   waiting for this NotificationRequest, we say that it is in the
   lockstep state.



Foster & Andreasen           Informational                      [Page 1]

RFC 3992        MGCP Lockstep State Reporting Mechanism    February 2005


   An endpoint that is in the lockstep state cannot perform any event
   processing and therefore also cannot generate a new Notify.
   Endpoints should only be in the lockstep state for a very short time.
   However, in adverse conditions, an endpoint could potentially end in
   the lockstep state without the Call Agent realizing it.  Clearly,
   this could have very negative consequences in terms of the service
   provided.

   The Lockstep package defined in this document defines extensions to
   the EndpointConfiguration and RestartInProgress commands that allow a
   Call Agent to request an endpoint to inform it when the endpoint is
   in the lockstep state for a specified period of time.

1.1.  Conventions Used in This Document

   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
   document are to be interpreted as described in BCP 14, RFC 2119 [1].

2.  Lockstep Package

   Package Name: LCK
   Version: 0

   Package Description: The purpose of this package is to provide a
   mechanism for reporting a condition in which an endpoint has been in
   the "lockstep state" for a specified period of time.

   There are two aspects of this package:

      *  The ability for a Call Agent to request endpoints to report if
         they are in lockstep state for a specified period of time.
         This is done with the EndpointConfiguration command, as
         described in section 2.1.

      *  The reporting mechanism itself, which is done with a new
         "lockstep" RestartMethod for the RSIP command as described in
         section 2.2.

2.1.  Request to Report Lockstep State

   The new "LCK/LST" EndpointConfiguration parameter is used by the Call
   Agent to request the reporting of "lockstep" state.  It uses the
   following ABNF:

      "LCK/LST:" 0*WSP LSTIME

      LSTIME = 1*(4DIGIT)



Foster & Andreasen           Informational                      [Page 2]

RFC 3992        MGCP Lockstep State Reporting Mechanism    February 2005


   where LSTIME is expressed in seconds, with a value ranging from 0 to
   9999.  A value greater than 2*T-HIST (refer to [2]) is RECOMMENDED.

   LSTIME is the amount of time the endpoint is in the lockstep state
   before reporting.  The timer starts when the endpoint enters the
   lockstep state and is canceled if the endpoint leaves the lockstep
   state before the timeout occurs.  The value provided remains in
   effect until explicitly changed (or a restart occurs).  If the
   endpoint is already in the lockstep state when a non-zero timer value
   is provided, the lockstep timer is simply started with the value
   provided; any existing lockstep timer is cancelled.  The value zero
   is used to turn off reporting.

   This parameter can be audited by using the AuditEndpoint command.
   The value returned is the last configured value, or the value zero
   when no value was configured.

2.2.  Lockstep Restart Method

   A new "lockstep" restart method is defined in the "LCK" package.  A
   RestartInProgress (RSIP) will be sent with this RestartMethod if the
   endpoint has been configured with a non-zero value for LSTIME and
   that timer has expired.  Note that once the lockstep timer has been
   set, it can fire only once per Notify command; however it is possible
   to set the timer more than once while an endpoint is in lockstep
   state (and hence rearm it for that particular Notify).  The syntax of
   the restart method is as per [2]:

      "RM" ":" 0*(WSP) "LCK/lockstep"

   RestartDelay (see [2]) is not used with the "lockstep" RestartMethod.
   Also, the "lockstep" RestartMethod does not define a service-state,
   and thus it will never be returned when auditing the RestartMethod.

3.  IANA Considerations

   The MGCP package title "Lockstep" with the name "LCK" and version
   number zero has been registered with IANA as indicated in Appendix
   C.1 in [2].

4.  Security Considerations

   Section 5 of the base MGCP specification [2] discusses security
   requirements for the base MGCP protocol that apply equally to the
   package defined in this document.  Use of a security Protocol such as
   IPsec (RFC 2401, RFC 2406) that provides per message authentication
   and integrity services is required to ensure that requests and
   responses are obtained from authenticated sources and that messages



Foster & Andreasen           Informational                      [Page 3]

RFC 3992        MGCP Lockstep State Reporting Mechanism    February 2005


   have not been modified.  Without these services, gateways and Call
   Agents are open to attacks.

5.  Normative References

   [1]  Bradner, S., "Key words for use in RFCs to Indicate Requirement
        Levels", BCP 14, RFC 2119, March 1997.

   [2]  Andreasen, F. and B. Foster, "Media Gateway Control Protocol
        (MGCP) Version 1.0", RFC 3435, January 2003.

Authors' Addresses

   Bill Foster

   Phone: +1 250 758 9418
   EMail: bfoster@cisco.com


   Flemming Andreasen
   Cisco Systems
   499 Thornall Street, 8th Floor
   Edison, NJ 08837

   EMail: fandreas@cisco.com


























Foster & Andreasen           Informational                      [Page 4]

RFC 3992        MGCP Lockstep State Reporting Mechanism    February 2005


Full Copyright Statement

   Copyright (C) The Internet Society (2005).

   This document is subject to the rights, licenses and restrictions
   contained in BCP 78, and at www.rfc-editor.org, and except as set
   forth therein, the authors retain all their rights.

   This document and the information contained herein are provided on an
   "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
   OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET
   ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED,
   INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE
   INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
   WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

Intellectual Property

   The IETF takes no position regarding the validity or scope of any
   Intellectual Property Rights or other rights that might be claimed to
   pertain to the implementation or use of the technology described in
   this document or the extent to which any license under such rights
   might or might not be available; nor does it represent that it has
   made any independent effort to identify any such rights.  Information
   on the ISOC's procedures with respect to rights in ISOC Documents can
   be found in BCP 78 and BCP 79.

   Copies of IPR disclosures made to the IETF Secretariat and any
   assurances of licenses to be made available, or the result of an
   attempt made to obtain a general license or permission for the use of
   such proprietary rights by implementers or users of this
   specification can be obtained from the IETF on-line IPR repository at
   http://www.ietf.org/ipr.

   The IETF invites any interested party to bring to its attention any
   copyrights, patents or patent applications, or other proprietary
   rights that may cover technology that may be required to implement
   this standard.  Please address the information to the IETF at ietf-
   ipr@ietf.org.

Acknowledgement

   Funding for the RFC Editor function is currently provided by the
   Internet Society.







Foster & Andreasen           Informational                      [Page 5]

一覧

 RFC 1〜100  RFC 1401〜1500  RFC 2801〜2900  RFC 4201〜4300 
 RFC 101〜200  RFC 1501〜1600  RFC 2901〜3000  RFC 4301〜4400 
 RFC 201〜300  RFC 1601〜1700  RFC 3001〜3100  RFC 4401〜4500 
 RFC 301〜400  RFC 1701〜1800  RFC 3101〜3200  RFC 4501〜4600 
 RFC 401〜500  RFC 1801〜1900  RFC 3201〜3300  RFC 4601〜4700 
 RFC 501〜600  RFC 1901〜2000  RFC 3301〜3400  RFC 4701〜4800 
 RFC 601〜700  RFC 2001〜2100  RFC 3401〜3500  RFC 4801〜4900 
 RFC 701〜800  RFC 2101〜2200  RFC 3501〜3600  RFC 4901〜5000 
 RFC 801〜900  RFC 2201〜2300  RFC 3601〜3700  RFC 5001〜5100 
 RFC 901〜1000  RFC 2301〜2400  RFC 3701〜3800  RFC 5101〜5200 
 RFC 1001〜1100  RFC 2401〜2500  RFC 3801〜3900  RFC 5201〜5300 
 RFC 1101〜1200  RFC 2501〜2600  RFC 3901〜4000  RFC 5301〜5400 
 RFC 1201〜1300  RFC 2601〜2700  RFC 4001〜4100  RFC 5401〜5500 
 RFC 1301〜1400  RFC 2701〜2800  RFC 4101〜4200 

スポンサーリンク

Creating Skins スキンを作成する

ホームページ製作・web系アプリ系の製作案件募集中です。

上に戻る