RFC5161 The IMAP ENABLE Extension

5161 The IMAP ENABLE Extension. A. Gulbrandsen, Ed., A. Melnikov, Ed.. March 2008. (Format: TXT=12220 bytes) (Status: PROPOSED STANDARD)

日本語訳
RFC一覧

参照

Network Working Group                                A. Gulbrandsen, Ed.
Request for Comments: 5161                        Oryx Mail Systems GmbH
Category: Standards Track                               A. Melnikov, Ed.
                                                           Isode Limited
                                                              March 2008


                       The IMAP ENABLE Extension

Status of This Memo

   This document specifies an Internet standards track protocol for the
   Internet community, and requests discussion and suggestions for
   improvements.  Please refer to the current edition of the "Internet
   Official Protocol Standards" (STD 1) for the standardization state
   and status of this protocol.  Distribution of this memo is unlimited.

Abstract

   Most IMAP extensions are used by the client when it wants to and the
   server supports it.  However, a few extensions require the server to
   know whether a client supports that extension.  The ENABLE extension
   allows an IMAP client to say which extensions it supports.

1.  Overview

   Several IMAP extensions allow the server to return unsolicited
   responses specific to these extensions in certain circumstances.
   However, servers cannot send those unsolicited responses until they
   know that the clients support such extensions and thus won't choke on
   the extension response data.

   Up until now, extensions have typically stated that a server cannot
   send the unsolicited responses until after the client has used a
   command with the extension data (i.e., at that point the server knows
   the client is aware of the extension).  CONDSTORE ([RFC4551]),
   ANNOTATE ([ANNOTATE]), and some extensions under consideration at the
   moment use various commands to enable server extensions.  For
   example, CONDSTORE uses a SELECT or FETCH parameter, and ANNOTATE
   uses a side effect of FETCH.

   The ENABLE extension provides an explicit indication from the client
   that it supports particular extensions.  This is done using a new
   ENABLE command.

   An IMAP server that supports ENABLE advertises this by including the
   word ENABLE in its capability list.




Gulbrandsen & Melnikov      Standards Track                     [Page 1]

RFC 5161               The IMAP ENABLE Extension              March 2008


   Most IMAP extensions do not require the client to enable the
   extension in any way.

2.  Conventions Used in This Document

   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
   document are to be interpreted as described in [RFC2119].

   Formal syntax is defined by [RFC5234] and [RFC3501].

   Example lines prefaced by "C:" are sent by the client and ones
   prefaced by "S:" by the server.  The five characters [...] means that
   something has been elided.

3.  Protocol Changes

3.1.  The ENABLE Command

   Arguments: capability names

   Result:    OK: Relevant capabilities enabled
              BAD: No arguments, or syntax error in an argument

   The ENABLE command takes a list of capability names, and requests the
   server to enable the named extensions.  Once enabled using ENABLE,
   each extension remains active until the IMAP connection is closed.
   For each argument, the server does the following:

   - If the argument is not an extension known to the server, the server
     MUST ignore the argument.

   - If the argument is an extension known to the server, and it is not
     specifically permitted to be enabled using ENABLE, the server MUST
     ignore the argument.  (Note that knowing about an extension doesn't
     necessarily imply supporting that extension.)

   - If the argument is an extension that is supported by the server and
     that needs to be enabled, the server MUST enable the extension for
     the duration of the connection.  At present, this applies only to
     CONDSTORE ([RFC4551]).  Note that once an extension is enabled,
     there is no way to disable it.

   If the ENABLE command is successful, the server MUST send an untagged
   ENABLED response (see Section 3.2).






Gulbrandsen & Melnikov      Standards Track                     [Page 2]

RFC 5161               The IMAP ENABLE Extension              March 2008


   Clients SHOULD only include extensions that need to be enabled by the
   server.  At the time of publication, CONDSTORE is the only such
   extension (i.e., ENABLE CONDSTORE is an additional "CONDSTORE
   enabling command" as defined in [RFC4551]).  Future RFCs may add to
   this list.

   The ENABLE command is only valid in the authenticated state (see
   [RFC3501]), before any mailbox is selected.  Clients MUST NOT issue
   ENABLE once they SELECT/EXAMINE a mailbox; however, server
   implementations don't have to check that no mailbox is selected or
   was previously selected during the duration of a connection.

   The ENABLE command can be issued multiple times in a session.  It is
   additive; i.e., "ENABLE a b", followed by "ENABLE c" is the same as a
   single command "ENABLE a b c".  When multiple ENABLE commands are
   issued, each corresponding ENABLED response SHOULD only contain
   extensions enabled by the corresponding ENABLE command.

   There are no limitations on pipelining ENABLE.  For example, it is
   possible to send ENABLE and then immediately SELECT, or a LOGIN
   immediately followed by ENABLE.

   The server MUST NOT change the CAPABILITY list as a result of
   executing ENABLE; i.e., a CAPABILITY command issued right after an
   ENABLE command MUST list the same capabilities as a CAPABILITY
   command issued before the ENABLE command.  This is demonstrated in
   the following example:

      C: t1 CAPABILITY
      S: * CAPABILITY IMAP4rev1 ID LITERAL+ ENABLE X-GOOD-IDEA
      S: t1 OK foo
      C: t2 ENABLE CONDSTORE X-GOOD-IDEA
      S: * ENABLED X-GOOD-IDEA
      S: t2 OK foo
      C: t3 CAPABILITY
      S: * CAPABILITY IMAP4rev1 ID LITERAL+ ENABLE X-GOOD-IDEA
      S: t3 OK foo again

   In the following example, the client enables CONDSTORE:

      C: a1 ENABLE CONDSTORE
      S: * ENABLED CONDSTORE
      S: a1 OK Conditional Store enabled








Gulbrandsen & Melnikov      Standards Track                     [Page 3]

RFC 5161               The IMAP ENABLE Extension              March 2008


3.2.  The ENABLED Response

   Contents:   capability listing

   The ENABLED response occurs as a result of an ENABLE command.  The
   capability listing contains a space-separated listing of capability
   names that the server supports and that were successfully enabled.
   The ENABLED response may contain no capabilities, which means that no
   extensions listed by the client were successfully enabled.

3.3.  Note to Designers of Extensions That May Use the ENABLE Command

   Designers of IMAP extensions are discouraged from creating extensions
   that require ENABLE unless there is no good alternative design.
   Specifically, extensions that cause potentially incompatible behavior
   changes to deployed server responses (and thus benefit from ENABLE)
   have a higher complexity cost than extensions that do not.

4.  Formal Syntax

   The following syntax specification uses the Augmented Backus-Naur
   Form (ABNF) notation as specified in [RFC5234] including the core
   rules in Appendix B.1.  [RFC3501] defines the non-terminals
   "capability" and "command-any".

   Except as noted otherwise, all alphabetic characters are
   case-insensitive.  The use of upper or lower case characters to
   define token strings is for editorial clarity only.  Implementations
   MUST accept these strings in a case-insensitive fashion.

      capability    =/ "ENABLE"

      command-any   =/ "ENABLE" 1*(SP capability)

      response-data =/ "*" SP enable-data CRLF

      enable-data   = "ENABLED" *(SP capability)

5.  Security Considerations

   It is believed that this extension doesn't add any security
   considerations that are not already present in the base IMAP protocol
   [RFC3501].

6.  IANA Considerations

   The IANA has added ENABLE to the IMAP4 Capabilities Registry.




Gulbrandsen & Melnikov      Standards Track                     [Page 4]

RFC 5161               The IMAP ENABLE Extension              March 2008


7.  Acknowledgments

   The editors would like to thank Randy Gellens, Chris Newman, Peter
   Coates, Dave Cridland, Mark Crispin, Ned Freed, Dan Karp, Cyrus
   Daboo, Ken Murchison, and Eric Burger for comments and corrections.
   However, this doesn't necessarily mean that they endorse this
   extension, agree with all details, or are responsible for errors
   introduced by the editors.

8.  Normative References

   [RFC2119]  Bradner, S., "Key words for use in RFCs to Indicate
              Requirement Levels", BCP 14, RFC 2119, March 1997.

   [RFC3501]  Crispin, M., "INTERNET MESSAGE ACCESS PROTOCOL - VERSION
              4rev1", RFC 3501, March 2003.

   [RFC5234]  Crocker, D., Ed., and P. Overell, "Augmented BNF for
              Syntax Specifications: ABNF", STD 68, RFC 5234, January
              2008.

   [RFC4551]  Melnikov, A. and S. Hole, "IMAP Extension for Conditional
              STORE Operation or Quick Flag Changes Resynchronization",
              RFC 4551, June 2006.

9.  Informative References

   [ANNOTATE] Daboo, C. and R. Gellens, "IMAP ANNOTATE Extension", Work
              in Progress, August 2006.






















Gulbrandsen & Melnikov      Standards Track                     [Page 5]

RFC 5161               The IMAP ENABLE Extension              March 2008


Editors' Addresses

   Arnt Gulbrandsen
   Oryx Mail Systems GmbH
   Schweppermannstr. 8
   D-81671 Muenchen
   Germany

   Fax: +49 89 4502 9758
   EMail: arnt@oryx.com


   Alexey Melnikov
   Isode Ltd
   5 Castle Business Village
   36 Station Road
   Hampton, Middlesex  TW12 2BX
   UK

   EMail: Alexey.Melnikov@isode.com































Gulbrandsen & Melnikov      Standards Track                     [Page 6]

RFC 5161               The IMAP ENABLE Extension              March 2008


Full Copyright Statement

   Copyright (C) The IETF Trust (2008).

   This document is subject to the rights, licenses and restrictions
   contained in BCP 78, and except as set forth therein, the authors
   retain all their rights.

   This document and the information contained herein are provided on an
   "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
   OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY, THE IETF TRUST AND
   THE INTERNET ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS
   OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF
   THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
   WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

Intellectual Property

   The IETF takes no position regarding the validity or scope of any
   Intellectual Property Rights or other rights that might be claimed to
   pertain to the implementation or use of the technology described in
   this document or the extent to which any license under such rights
   might or might not be available; nor does it represent that it has
   made any independent effort to identify any such rights.  Information
   on the procedures with respect to rights in RFC documents can be
   found in BCP 78 and BCP 79.

   Copies of IPR disclosures made to the IETF Secretariat and any
   assurances of licenses to be made available, or the result of an
   attempt made to obtain a general license or permission for the use of
   such proprietary rights by implementers or users of this
   specification can be obtained from the IETF on-line IPR repository at
   http://www.ietf.org/ipr.

   The IETF invites any interested party to bring to its attention any
   copyrights, patents or patent applications, or other proprietary
   rights that may cover technology that may be required to implement
   this standard.  Please address the information to the IETF at
   ietf-ipr@ietf.org.












Gulbrandsen & Melnikov      Standards Track                     [Page 7]

一覧

 RFC 1〜100  RFC 1401〜1500  RFC 2801〜2900  RFC 4201〜4300 
 RFC 101〜200  RFC 1501〜1600  RFC 2901〜3000  RFC 4301〜4400 
 RFC 201〜300  RFC 1601〜1700  RFC 3001〜3100  RFC 4401〜4500 
 RFC 301〜400  RFC 1701〜1800  RFC 3101〜3200  RFC 4501〜4600 
 RFC 401〜500  RFC 1801〜1900  RFC 3201〜3300  RFC 4601〜4700 
 RFC 501〜600  RFC 1901〜2000  RFC 3301〜3400  RFC 4701〜4800 
 RFC 601〜700  RFC 2001〜2100  RFC 3401〜3500  RFC 4801〜4900 
 RFC 701〜800  RFC 2101〜2200  RFC 3501〜3600  RFC 4901〜5000 
 RFC 801〜900  RFC 2201〜2300  RFC 3601〜3700  RFC 5001〜5100 
 RFC 901〜1000  RFC 2301〜2400  RFC 3701〜3800  RFC 5101〜5200 
 RFC 1001〜1100  RFC 2401〜2500  RFC 3801〜3900  RFC 5201〜5300 
 RFC 1101〜1200  RFC 2501〜2600  RFC 3901〜4000  RFC 5301〜5400 
 RFC 1201〜1300  RFC 2601〜2700  RFC 4001〜4100  RFC 5401〜5500 
 RFC 1301〜1400  RFC 2701〜2800  RFC 4101〜4200 

スポンサーリンク

MySQLやMariaDBは標準ではログローテートされない

ホームページ製作・web系アプリ系の製作案件募集中です。

上に戻る